Bitswap

Archive for the ‘4.03 H.323’ Category

Configuration for IP-to-IP Gateway

Posted by Andy on May 7, 2009

Example 8-12 Configuration for IP-to-IP Gateway

voice service voip

allow-connections h323 to h323

supplementary-service h450.2

supplementary-service h450.3

supplementary-service h450.12

h323

emptycapability

h225 id-passthru

h225 connect-passthru

h245 passthru tcsnonstd-passthru

interface Loopback0

ip address 2.1.1.1 255.255.255.0

h323-gateway voip interface

h323-gateway voip id IPIPGW-zone ipaddr 1.1.1.1 1719

h323-gateway voip h323-id IPIPGW

h323-gateway voip bind srcaddr 2.1.1.1

dial-peer voice 1 voip /* To Unified CM endpoints */

destination-pattern 4…

session target ras

dtmf-relay h245-alphanumeric

codec g729r8

no vad

dial-peer voice 1 voip /* To Unified CME endpoints */

destination-pattern 3….

session target ras

dtmf-relay h245-alphanumeric

codec g729r8

no vad

via Cisco Unified Communications SRND Based on Cisco Unified Communications Manager 7.x – Call Processing  [Cisco Unified Communications Manager (CallManager)] – Cisco Systems.

Posted in 4.00 Implement and Troubleshoot Voice Gateways, 4.03 H.323, 4.07 IP-IP Gateway/CUBE | Leave a Comment »

Cisco Unified Communications SRND Based on Cisco Unified Communications Manager 7.x – Call Processing  [Cisco Unified Communications Manager (CallManager)] – Cisco Systems

Posted by Andy on May 4, 2009

The arq reject-unknown-prefix command is is used to guard against potential call routing loops across redundant Unified CM trunks.

via Cisco Unified Communications SRND Based on Cisco Unified Communications Manager 7.x – Call Processing  [Cisco Unified Communications Manager (CallManager)] – Cisco Systems.

Posted in 4.03 H.323 | Leave a Comment »